Ajax MotionCam — Wireless Motion Sensor with Camera for Alarm verification
The Ajax MotionCam wireless Motion detection detector warns users when a threat is detected. Following the warning message, the wireless sensor will send an animated series of photos to assess the situation and confirm the reaction.
The principle of operation of the Ajax MotionCam wireless motion sensor
Ajax MotionCam wireless Motion Detector takes photos only when alarmed. The received data is transmitted via a secure Wings radio channel, which uses encryption when transmitting and storing information. The sensitivity of the MotionCam is adjustable. A motion sensor with a camera is able to ignore pets up to 50 cm tall and weighing up to 20 kg, thanks to the SmartDetect digital algorithm. But if the pet manages to trigger an alarm, the photo report that the user immediately receives will show that the object under protection is not in danger. The safe and reliable transmission of the received data is ensured by the simultaneous use of two radio protocols: Jeweller, which reports alarms and Wings, which transmits photos. The transfer of media files from the event takes less than 9 seconds after the motion is detected, and the user will receive an alarm notification immediately. The place to install the wireless sensor for the MotionCam alarm should be chosen taking into account the communication range with the alarm control panel, which is up to 1700 meters, provided there are no obstacles. Ajax MotionCam works for up to 4 years from pre-installed batteries. Installing and configuring a wireless sensor does not require special knowledge: the device is mounted on a SmartBracket mount without disassembling the case, and the connection to the alarm control panel takes place via the Ajax mobile application by scanning a QR code.
